Benewake Offers A Low Cost Solution for Aunattended ETC Quick Toll Collection
In order to achieve fast toll tax collection without stopping at toll plaza, most toll plazas will use unattended ETC quick toll collection. ETC charges are mostly based on the vehicle model to determine the amount of charge. Different models, the ETC charge standards are also different. When there are many vehicles in the toll station, the distance between adjacent vehicles is too small, and the toll may be missed. In addition, in order to avoid toll fees, some large vehicles will replace ETC CARDS of small vehicles for payment.
Therefore, different types of vehicles need to be accurately judged and separated to solve the problem of omission and evasion of tolls.
By installing Benewake TF LiDAR and using it with a camera, vehicles can be accurately judged and separated, so as to achieve accurate and efficient ETC charging.
Installation Method: Install 2-3 single-point LiDARs on the side of the entrance/intersection of toll plaza to detect the designated area diagonally downward. As shown in Figure 1, the installation height can be set to 1.3-1.5m, and 2m from the middle of the road in the horizontal direction. To cover the area of 36*36 in the middle of the road, it can be installed horizontally using three TFmini Plus, and inclined downward to detect angle "a" is about 35°.
Application Principle: It is known that the detection distance of the three LiDARs to the ground remains unchanged. When a car passes by, the measured distance value of the three LiDARs becomes smaller, and the range value of the LiDAR increases when the car leaves, and it can be judged that a car passed by; Divide the car according to the change of distance. Consider the objects that cannot be effectively detected by the LiDAR, such as trailer hooks, with the aid of cameras for auxiliary identification.
Program advantages:
1. small FOV, accurate detection and low false alarm rate
2. Can be installed near the side of the road, low installation difficulty, easy installation, low cost
3. Single-point LiDAR scheme, high cost performance, low cost of product
PRODUCTS
TFmini-S 12m cost-effective distance sensor/TFmini Plus 12m IP65 distance sensor
- |
- +1 赞 0
- 收藏
- 评论 0
本文由翊翊所思转载自Benewake,原文标题为:Tollgate Vehicle Separation Application Introduction,本站所有转载文章系出于传递更多信息之目的,且明确注明来源,不希望被转载的媒体或个人可与我们联系,我们将立即进行删除处理。
相关推荐
Benewake LiDAR Sensors Improve Vehicle Mobility and Overcomes Parking Problem in Three-dimensional Parking
Three-dimensional parking of mainly nine types is available in the market. These include lift-and-slide, vertical circulation, simple lifting, vertical lifting, planar movement, stacking and multi-layer circulation. Lift-and-slide, the most common type, is three-dimensional with lifting carrier or slide drive-in and out, usually unmanned. In other words, the vehicle is moved to position after you leave the vehicle. Benewake LiDAR sensors improve vehicle mobility and overcomes parking problem in three-dimensional parking.
应用方案 发布时间 : 2021-08-02
【应用】北醒基于近红外ToF激光雷达提出全套料位检测方案,安装配置简单,结果真实可靠
北醒基于近红外ToF激光雷达提出了一套料位检测方案,通过北醒雷达获取准确的库存数据,方案中配备网络传输模块,最终通过终端设备,随时随地检测筒仓内的库存信息。整套方案中北醒可提供激光雷达设备、无线传输模块,以及第三方监控软件(如需独立部署北醒可提供技术支持)。
应用方案 发布时间 : 2022-07-28
【应用】北醒激光雷达传感器助力无人机实现精准定高,安装简单、精度高
人为操控无人机难度较大,GPS存在信号丢失、精度差等问题,采用北醒激光雷达传感器可以克服这两种操作的技术难点,辅助无人机实现精准定高或稳定降落。北醒激光雷达传感器是一种高频发射近红外光的低功耗、高精度、小体积的测距模块,将其安装在无人机下方,可以实时探测雷达到正下方地面的距离信息并反馈给无人机,使无人机在下降过程或悬停过程中,可以及时调整下降速度或飞行高度。
应用方案 发布时间 : 2020-06-08
北醒(Benewake)激光雷达传感器选型指南
目录- 公司简介 短距系列激光雷达模组测距传感器 中距系列激光雷达测距传感器 长距系列激光雷达测距传感器 工业版激光雷达测距传感器 选型参数对比表
型号- CE30,HORN-X,HORN,HORN系列,TF02-PRO,HORN-X2 PRO,TF40,TF-LUNA,TFMINI,HORN-RT,TFMINI PLUS,TF,TF03,TF03-180,TF02,TF-LUNA-PARKING,TFMINI-I,TF02-I,TF系列,TF03-100,TF350,TFMINI-S
北醒激光雷达距离传感器选型表
提供北醒激光雷达距离传感器选型, 测量范围:0.04m~350m@90%反射率;0.04m~40m@10%反射率, 帧率:1-1000Hz, 距离分辨率:1cm, 刷新率:20~30fps, 视场角:0.5°~ 132°x9°, 输出数据:单点距离值、ROI区域内障碍物距离值和角度值、点云数据, 通信:UART; I²C; I/O; RS485; RS232; CAN; TCP; UDP.
产品型号
|
品类
|
测量范围@90%反射率
|
帧率
|
距离分辨率
|
准确度
|
准确率补充
|
视场角
|
输出数据
|
通信
|
输入电压
|
功耗
|
尺寸(长*宽*高)
|
重量
|
TFMINI-S_UART-IIC-I/O
|
近距离激光雷达传感器
|
0.1m~12m
|
1-1000Hz
|
1cm
|
±6cm@(0.1m-6m)
|
±1%@(6m-12m)
|
2°
|
单点距离值
|
UART;I²C;I/O
|
5V±0.1V
|
≤0.7W
|
42mm*15mm*16mm
|
5g±0.3g
|
选型表 - 北醒 立即选型
北醒激光雷达工业产品及应用领域介绍
描述- 本资料主要介绍北醒研发的短距单点/中距/长距激光雷达传感器产品,以及产品应用案例分析,包括有:传送带分拨AGV避障、货箱拆卸AGV、SMT上下料AGV、物料运输AGV、立库穿梭车避障、激光导航叉车避障、消毒机器人、服务机器人农场饲料罐/陶瓷料罐料位检、塔吊预警/塔吊吊环位置检、便携安防报警器触发、手持甲烷检测仪测距、摄像头辅助对焦。
型号- TFMINI PLUS,TF02-PRO,TF03-180,TF03,TFMINI-I,TF02-I,TF40,TF-LUNA,TF03-100,TF350,TFMINI-S
SJ-GU-TF-Luna A05 TF-Luna LiDAR module (Short-range distance sensor)Product specification
型号- SJ-GU-TF-LUNA A05,TF-LUNA
【产品】支持UART/I²C接口的TFmini/-S系列高性价比激光测距模组,测量范围0.3-12M
北醒推出的TFmini系列激光测距模组拥有低成本、体积小、低功耗三大优点,具有多种接口,满足不同客户需求。 TFmini是北醒在推进激光雷达低成本化进程中里程碑式的一步,配以独特的光学、结构和电子设计。作为升级版本,TFmini-S基于TFmini的应用经验对其进行了升级,依然小巧轻便的同时,具有更高性能,适用于更广泛应用领域。
新产品 发布时间 : 2020-05-27
北醒亮相2022 IOTE深圳物联网展,致力于为客户提供激光雷达及解决方案
2022 IOTE深圳物联网展开幕在即!北醒作为品牌参展商,致力于为客户提供激光雷达及解决方案,已形成成熟产品体系与物联网行业经验,用科技让万物联动。目前北醒TF系列产品在物联网领域已涵盖了智慧生活、智慧城市、智慧农业、智慧工业、智慧医疗、智慧教育六大模块。
原厂动态 发布时间 : 2022-11-27
【应用】北醒激光雷达触发摄像头区分车型方案,从而实现精准、高效的ETC收费
为缓解收费站口拥堵情况,交通运输部采用ETC自动不停车收费的方式,节省车上人员时间,缓解交通压力,由于车型不同,收费标准不同,故ETC收费需要有区分车型功能,北醒激光雷达触发摄像头区分车型方案,精准判断车轴车型,避免因车距过小遗漏收费、恶意换卡片逃避过高路费等情况的发生,从而实现精准、高效的ETC收费。
应用方案 发布时间 : 2021-01-07
北醒TFmini Plus激光雷达助迦智科技AGV工作台的辅助定位和作业靠近检测,提升仓储物流效率
迦智信赖北醒品牌,激光雷达装在迦智的产品上,要确保稳定可靠,不能出差错;北醒的TFmini Plus产品比较精巧,能够很好地与迦智机器人集成;北醒的服务团队在批量导入过程中,通力配合,能够及时响应迦智的需求。
应用方案 发布时间 : 2022-07-28
电子商城
登录 | 立即注册
提交评论