Ultra High Power Density Synchronous Full Switching Mode Converter with a Fixed LDO Output, Supporting 4.5V~22V Input Voltage Range
The birth and outbreak of new terminal applications drive the continuous growth of data storage demand, and promote the continuous iterative replacement of SDRAM, making the efficient and stable power management chip become more and more important. Long Microelectronics launches a highly integrated and ultra-high power density synchronous full switching mode converter IS6630A/C/D, which realizes three-way output voltage in ultra-small volume, provides DDR integrated power supply solution, and provides a more efficient and low power consumption working environment for the terminal.
Protocol introduction
IS6630A/C/D full switch mode converter, using 3mm * 3mm * 0.85mm QFN package, provides a complete integrated power solution for SDRAM with ultra high power density, with a fixed LDO output, supporting a wide input voltage (4.5V~22V) range and a continuous output current of up to 10A. The product features are described as follows:
●IS6630A With fully integrated VDDQ (BUCK), VTT (LDO), VPP (LDO) and VTTREF power channels; I S6603C / D with fully integrated VDDQ (LDO), VDD 1 (LDO), VDD 2 (BUCK) power channels
● put to use TCOTTMControl mode to achieve a rapid and transient response
●Continuous output current of 10A
● Switch frequency: 500 kHz / 700 kHz
● Excellent load adjustment rate and linear adjustment rate, with an accuracy of 1%
● Under VIN=12V,VOUT=1.2V conditions, the efficiency in the load range can reach more than 92%
● Support internal soft start, programmable valley value flow limit
● Internal integration of OCP, NOCP, OVP, UVLO, OTP and other protection functions
product superiority
1. The control loop is simple, and the transient response speed is extremely fast
IS6630A / C / D using the long industrial micropatent TCOTTMIn control mode, the FB is directly compared with REF to adjust the output voltage, the feedback line makes no complex compensation, there is no RC network delay; and the control loop can respond quickly to the output voltage change without waiting for the clock. Therefore, there is no clock delay, and the transient response speed can be achieved using only a small amount of ceramic capacitor. The following figure shows a schematic comparison of the transient response of the current mode control and the COT control mode. Obviously, the COT control mode is much faster.
2. RAMP ramp compensation, support for all-ceramic output capacitance
IS6630A / C / D integrates the slope compensation network, namely RAMP signal, inside the chip, which is superimposed on FB to simulate the resistance ripple of ESR and avoid the unstable phenomenon of "multi-pulse oscillation". IS6630A / C / D can work stably with the all-ceramic capacitor, saving space and reducing the cost.
3. Built-in integrator, high output voltage accuracy
IS6630A / C / D introduces a slow digital integrator to continuously correct the reference voltage REF, so as to improve the accuracy of the output voltage and eliminate the half-ripple bias existing in COT. The digital integrator also makes IS6630A / C / D with good linearity, with the output voltage accuracy up to ± 1% at different load current and input voltage.
4. High efficiency, low power consumption
Thanks to the technical optimization of integrated MOS tube low on resistance and drive circuit, the efficiency of IS6630A / C / D can be up to 92% under VIN=12V,VOUT=1.2V conditions. Under the condition of light load, the chip is fixed to DCM mode, which further reduces the power consumption of the chip and improves the overall working efficiency of the chip. In addition, the IC also has USM ultrasonic mode: compared with the ordinary DCM mode, open the low side MOS tube more, significantly improve the switching frequency, and avoid the IC light load switching frequency falling into the human ear sound frequency range in the DCM mode, the obvious audible noise.
Series selection
IS6630A/ C / D support-40℃ to + 125℃ ambient temperature, suitable for data transmission rate / wide output voltage range of pen, server, data center and other fields. IS6630 It can provide a variety of three-way output voltage choices, which is conducive to terminal application engineers to design diversified schemes according to different application scenarios.
Application scenario instances
The input voltage of the laptop motherboard is determined by the battery specification and the adapter. Generally, the laptop adapter voltage is 19V, and the battery can be divided into 3S (9V-13.2V) and 4S (12V-17.6V). The following takes the 4S battery powered notebook motherboard as an example to introduce the application design example of IS6630A power supply for DDR 4:
Conditions of application: VIN = 12 V ~ 19V,VOUT=1.2V(Imax=10A),VTT=0.6V(Imax=1A),VPP=2.5V (Imax = 1 A), Load Step: 0A ~7A & 3A ~10A, PKPK of VOUT 120 mV (± 5%).
First select the switch frequency, the IS6630A switch frequency is 500 kHz and 700 kHz respectively, it is generally recommended to choose 700 kHz;
Secondly, the inductance value is determined according to the inductance current ripple is 20%~40% of the full load output current. The full load current is 10A, then the range of the inductance current ripple is 2A ~4A. According to the formula, combined with VOUT=1.2V, Fsw = 700 kHz, calculated VIN = 12 V, the inductance value range is 0.39 μH ~ 0.77 μH, VIN = 19 V, the inductance value range is 0.4 uH ~ 0.8 uH, the final inductance value is 0.68 μH;
Finally, according to the design tool provided by Chang Micro, appropriate output capacitors are selected for VDDQ, VTT and VPP. Here VDDQ uses 622 uF ceramic capacitors, VTT uses 14.7 μF and 122 μF ceramic capacitor in parallel, and 11 μF and 147 μF ceramic capacitor for VPP in parallel. Thus, the key parameters of this application have been determined, and the following is the corresponding measured waveform.
- |
- +1 赞 0
- 收藏
- 评论 0
本文由咪猫转载自Innovision Semiconductor News，原文标题为:Ultra high power density synchronous full switching mode converter，本站所有转载文章系出于传递更多信息之目的，且明确注明来源，不希望被转载的媒体或个人可与我们联系，我们将立即进行删除处理。
相关推荐
Eaton Expands Reach into European Data Center Market by Making Strategic Investment in NordicEPOD
Eaton (NYSE:ETN) today announced it has completed a significant strategic investment in NordicEPOD AS, formerly a wholly-owned subsidiary of CTS Nordics, which designs and assembles standardized power modules for data centers in the Nordic region.
厂牌及品类 发布时间 : 2024-06-22
Innovision Semiconductor‘s Multi-phase Controller IS6201A Won the “Best Power Management IC of the Year“ in the IIC 2022
IS6201A, a multi-phase controller independently developed and designed by ChangMicroelectronics, won the “Best Power Management IC of the Year“ award of “2022 China IC Design Achievement Award“ with technological innovation and excellent product performance.
厂牌及品类 发布时间 : 2023-10-31
Innovision Semiconductor Attended Hardware Developer Conference with a Full Set of VRM Power Aolutions
The “Hardware Developer Conference“ sponsored by Hard10 was successfully concluded in the Conference Center of Southern University of Science and Technology in Shenzhen on December 9. Innovision Semiconductor was invited to attend the event to share the speech of “AI Chip Power Solution“, accompanied by the appearance of a full set of VRM power solutions.
厂牌及品类 发布时间 : 2023-12-30
Innovision Semiconductor（长工微电子）电源管理芯片选型指南
描述- 长工微坐落于东莞松山湖万汇云谷，成立于2016年5月，由曾就职于国内外知名公司半导体多年的研发主管和丰富经验的工程师组成，专注于提供高性能高品质的大电流电源管理芯片设计，公司坚持自主开发，共申请专利65项，产品可广泛应用在服务器，工业通讯，计算机，消费电子等多个领域。
型号- IS6202A,IS6103A,IS6630A,IS6620A,IS6101A,IS6630D,IS6630C,IS6810A,ISM6403A,ISM6401A,IS6806A,IS6608A,IS66066,IS6104A,IS6631B,IS6302A,IS6203A,IS6631A,IS6201A,IS6102A,IS6605B,IS6605A,IS6811A,ISM6636A,IS6811B,IS6607A,IS6607H,IS6805A,ISM6402A,IS6809A,IS6807A,IS6807B,IS6609A
IS6630A/C/D with Three-way Output Enables DDR Power Supply Integration, Saving the Space on the PCB Board And the Required Devices
As a fully integrated DDR power supply integrated power supply solution, IS6630A / C / D is mainly used in high data transmission rate / wide output voltage range of pen, data center and other industries, taking into account high efficiency, high performance, while having a smaller application volume, can match the mainstream market demand, and actively enable the development of DDR industry.
应用方案 发布时间 : 2023-10-02
【产品】开关转换器IS6630C，内部集成两路LDO，可为LPDDR5提供完整高功率密度电源解决方案
IS6630C可为LPDDR5提供完整的高功率密度电源解决方案，其内部集成了同步降压型开关变换器（VDD2），该变换器可在宽输入电压（4.5V~22V）范围内提供高达10A的连续电流，具有出色的负载和线性调整率。
产品 发布时间 : 2023-04-02
【产品】QFN16封装的开关转换器IS6630A可在宽输入电压4.5~22V提供高达10A连续电流
长工微电子开关转换器IS6630A可为DDR4，DDR3/DDR3L提供完整的高功率密度电源解决方案，其内集成同步降压型开关变换器，可在宽输入电压4.5~22V范围内提供高达10A的连续电流，具有出色的负载和线性调整率。
产品 发布时间 : 2023-04-01
长工微电子授权世强硬创代理，提供高密度DDR4电源解决方案
2022年12月12日，世强先进（深圳）科技股份有限公司（下称“世强先进”）和东莞长工微电子有限公司（下称“长工微电子”）签署战略合作协议，授权世强先进全线代理其旗下电源管理IC、开关转换器、多相控制器、智能功率级电源模块、降压电源模块、电子保险丝等产品。
公司动态 发布时间 : 2023-02-01
【应用】全开关模式转换器IS6630A/C/D赋能DDR供电一体化，最高带载10A，内含固定LDO输出
针对这一市场需求，长工微电子自主研发推出IS6630A/C/D——最高带载10A的全开关模式转换器，内含固定LDO输出，可支持全集成DDR供电方案。该电源方案将上述提及的DDR三路电源供电的需求高度集成到一颗3mm*3mm*0.85mm QFN封装的芯片上。
应用方案 发布时间 : 2023-02-05
【产品】4.5V~22V输入的同步降压型开关变换器IS6630D，内集成两路LDO，输出电流10A
长工微同步降压型开关变换器IS6630D可为LPDDR4X提供完整的高功率密度电源解决方案，内集成同步降压型开关变换器，可在宽输入电压4.5~22V范围内提供高达10A的连续电流，具有出色的负载和线性调整率。
产品 发布时间 : 2023-03-02
【IC】长工微新推超高功率密度的同步全开关模式转换器IS6630A/C/D，以超小体积实现三路输出电压
长工微电子推出全集成、超高功率密度的同步全开关模式转换器IS6630A/C/D，以超小体积实现三路输出电压，提供DDR供电一体化电源解决方案，为终端提供更加高效、低功耗的工作环境。
新产品 发布时间 : 2023-03-06
Innovision Semiconductor(长工微)电源模块选型表
Innovision Semiconductor(长工微)电源模块选型表：Iout(A)：6A-8A，Vout(V)：0.6V-5V，Output voltages(V) ：0.6-3.3V
|
产品型号
|
品类
|
Vout(V)
|
Vin(V)
|
Iout(A)
|
|
ISM6401A
|
电源模块
|
0.6V~5V
|
2.5V~16V
|
8A
|
选型表 - Innovision Semiconductor 立即选型
Suning Cloud Yuhua Data Center Adopts Rosenberger HDCS Cabling System
Rosenberger has many years experience in data center construction, Focous on customers‘ need, to provide customers a set of practical data center solutions with reasonable product selection, and build a data center with high stability and high economic efficiency for Suning Cloud. , The basic link network of scalability and practicality.
应用方案 发布时间 : 2020-11-26
电子商城
授权代理品牌：集成电路
授权代理品牌：分立元件
授权代理品牌：接插件及结构件
授权代理品牌：部件、组件及配件
授权代理品牌：电源及模块
授权代理品牌：电子材料
授权代理品牌：仪器仪表及测试配组件
授权代理品牌：电工工具及材料
授权代理品牌：机械电子元件
授权代理品牌：加工与定制
我要提问
登录 | 立即注册
提交评论