G-NiceRF LoRa Backscatter Device LoRa1276-C1 Provides Long-Range Communication with Low-Power

时间： 2024-06-05 来源：G-NiceRF Official Website

技术问答

Deficiencies in Current Wireless Communication Technology

Current wireless communication technologies tend to offer only one of two options: low-power, cheap, but short-range or high-power, long-range, but expensive. A comparison was made against Wi-Fi, SigFox, Zigbee, and LTE-M active radio technologies, which were found to be significantly more expensive ($4 to $6 per unit), and also had much higher power requirements. While all the aforementioned have long-range communication capabilities, their energy and economic requirements made them less ideal for large-scale use in embedded systems.

Supercharging the Use of Backscatter

Ambient backscatter technology uses radio frequencies already being produced by other devices to generate its own electricity and reflect a signal to other devices. These radio signals can be Wi-Fi, radio, television, or mobile device signals. This has a great advantage of not requiring or depending on a built-in or physically connected power source and is also an ultra-low-cost solution.

However, ambient backscattering also has some downsides: its range is quite limited, it can be unreliable, and in medical applications the attenuation of RF signals by the human body causes the range of medical or wearable devices to be significantly reduced.

Hence, the addition of LoRa, a Low-Power Wide-Area-Network (LPWAN) specification, that sends smaller packets at lower power and has a longer range. This adds the required sensitivity to make the backscattering technique operational over greater distances with the addition of a small power source providing 9.25 micro-Watts. The sensitivity was brought down to -149 dBm, had a data rate of 18bps-37.5kbps, and could be powered by a button cell battery, a printed battery, or a small solar cell.

G-NiceRF LoRa1276-C1 LoRa Backscatter Device integrates Semtech RF transceiver chip SX1276, which adopts LoRa Spread Spectrum modulation frequency hopping technique. The features of long distance and high sensitivity (-139 dBm) make this module perform better than FSK and GFSK module. Multi-signal won't affect each other even in crowd frequency environment; it comes with strong anti-interference performance. This module is 100mW and ultra small size, widely used in AMR,remote industrial control filed.

发送到邮箱 |
+1 赞 0
收藏
评论 0
| 转发至：

本文由咪猫转载自G-NiceRF Official Website，原文标题为:LoRa Backscatter Device Provides Long-Range Communication with Low-Power，本站所有转载文章系出于传递更多信息之目的，且明确注明来源，不希望被转载的媒体或个人可与我们联系，我们将立即进行删除处理。

全部评论（0）

暂无评论

思为无线采用sx1276 RF芯片的LoRa模块有哪些？——LoRa1276/1276-C1/1276F30

思为无线推出的LoRa1276和LoRa1276-C1模块设计为100mW的输出功率，内置天线静电保护，体积十分小巧，在无线抄表，远程工控等行业得以广泛地应用。LoRa1276F30是一款1W大功率远距离的LoRa无线收发模块，多路信号无阻塞，具有超强的抗干扰性，在远程工控等行业得以广泛地应用。

产品发布时间 : 2024-06-30

LoRa1276-C1 Wireless Module with Output Power of 100mW is Suitable for Industrial Applications, Has Obtained FCC, IC, and CE certifications

The Lora1276-C1 wireless module utilizes Semtech‘s SX1278 and excels in industrial applications due to its outstanding performance. It has obtained FCC, IC, and CE certifications.

产品发布时间 : 2024-11-09

Lora1276-C1无线模块可用于工业，通过获得FCC、IC、CE认证，超高接收灵敏度-139dBm

LoRa1276-C1无线模块性能在工业中应用其突出优势有通过获得FCC、IC、CE认证，确确保无线模块符合相应地区或国家的技术标准和法规要求，提高产品的市场竞争力。其超高的接收灵敏度保证了即使在复杂环境下也能稳定通信。此外，低功耗设计使其在节能和稳定性方面表现出色。内置的天线静电保护进一步提高了设备的可靠性和耐用性。

产品发布时间 : 2024-06-11

LoRa无线模块的RSSI功能是什么？

RSSI功能是指信号强度的指示，无线发送层的可选部分，用来判定链接质量，以及是否增大广播发送强度。本文介绍RSSI功能。

技术探讨发布时间 : 2024-07-27

G-NiceRF无线模块选型表

提供G-NiceRF 2.4G无线模块,3D计步模块,ANT+无线串口模块,ASK发射模块,ASK模块四件套,LORA无线模块,UWB双向测距定位模块,低功耗蓝牙模块,对讲机模块,全双工无线数据语音模块,数字无线音频收发模块,卫星定位模块,无线模块,无线射频模块,无线透传模块,无线音频收发模块产品选型，可多尺寸选择，最大工作频率达6489.6MHz/7987.2MHz

产品型号	品类	尺寸(mm)	等级认证标准	工作频率(MHz)	输出功率(mW、W)
LORA1276-C1-915MHZ	LORA无线模块	16mmx16mm	ROHS,IC,ID,FCC	915MHz	100mW

选型表 - G-NiceRF 立即选型

How to Enhance LoRa Communication Effectiveness by Improving Anti-Interference Capabilities

Enhancing LoRa‘s anti-interference capabilities to improve communication quality can be approached from multiple aspects, including hardware design, software optimization, the use of frequency hopping, and optimizing spreading factors and bandwidth, among other factors.

设计经验发布时间 : 2024-08-28

思为无线LoRa1276-C1无线模块已通过FCC ID、CE-RED和IC ID国际认证

思为无线推出的LoRa1276-C1模块采用了Semtech SX1276芯片，已通过FCC ID、CE-RED和IC ID国际认证。广泛应用于私有协议和LoRaWAN系统。该模块具备先进的LoRa扩频调制跳频技术，具有高灵敏度和远距离通信能力，同时具备强大的抗干扰能力。严格遵循无铅工艺进行生产和测试，以确保符合环保标准。

产品发布时间 : 2024-05-28

思为无线LoRa前端模块LoRa127X与LoRa127X-C的差异之处

思为无线的LoRa127X与LoRa127X-C1系列无线模块都是采用同一款主芯片，产品特性一样。不同的是产品认证不同，最大的差异是在于因考虑客户的差异化需求把LoRa127X-C1 系列模块引脚有所改变，从而模块本身尺寸也有所改变。

技术探讨发布时间 : 2024-05-24

思为无线推出小体积100mW输出功率的无线模块LoRa127X-C1系列，休眠电流低至1.5μA

思为无线LoRa127X-C1系列无线模块是采用Semtech公司SX127X为主芯片，该模块采用了LoRa扩频调制跳频技术高效的接收灵敏度和超强的抗干扰性能，其通信距离，接收灵敏度都远超现在的FSK、GFSK调制，且多个传输的信号占用同一个信道而不受影响，具有超强的抗干扰性。此模块天线开关由芯片内部集成控制，小巧的体积搭配100mW的输出功率，在无线抄表，远程工控等行业得以广泛地应用。

产品发布时间 : 2024-07-05

LoRa127X-C1系列产品规格书

型号- LORA1278-C1-433,LORA1276-C1-915,LORA1276-C1,LORA1278-C1,LORA127X-C1,LORA1276-C1-868,LORA1278-C1-490,LORA127X-C1 系列

数据手册 - G-NICERF - V3.0 - 2020-11 PDF 中文下载

Market Price and Development Prospects of LoRa Module

LoRa is very popular in the Internet of Things market because its long-distance communication technology has the advantages of low power consumption and low cost. The LoRa module developed based on the SX1276/SX1278 chip also shows a steady increase in demand. So, what is the market price of LoRa wireless module, and what is the future development trend of LoRa module?

技术探讨发布时间 : 2024-06-06

What is the RSSI Function of LoRa Module

Many customers will ask us a question when purchasing our SX1276 LoRa module LoRa1276-C1, what is the RSSI function? What are the LoRa modules with RSSI function? Here, NiceRF explains what the RSSI function is.

技术探讨发布时间 : 2024-06-05